You now have a hollow light bulb and are ready to move on to the next step. Tap the sides of the lightbulb to cause any remaining debris to fall out of the bottom onto the newspaper. Use the pliers to remove the remaining inner parts. – by moving the screwdriver back in forth inside the lightbulb. Use a large Phillips screwdriver to detach the remaining inner parts of the lightbulb – the glass mount/support, the tungsten filament, etc. Next, remove the clear inner tube from the lightbulb, again using the pliers. Use the pliers to remove any remaining pieces. You can do this by sticking the flathead screwdriver through the opening and moving it back and forth until the insulator is fully broken off. When you have the ring fully removed, use a small flathead screwdriver to remove the base glass insulator (black piece of plastic) at the bottom of the bulb. Work your way around the edge of the ring, gripping it with the pliers and pulling and twisting until the ring comes off. ![]() Start by using pliers to remove the bottom ring from the base of the lightbulb. The actual process of hollowing out a lightbulb requires a certain amount of care and precision as you obviously don’t want to break the lightbulb glass. Using a piece of newspaper will make tidying up afterward easier as it will catch all the falling pieces while you are hollowing out the lightbulb. Step 1 – Begin by Hollowing Out the Lightbulbīefore you get started, it is a good idea to lay a couple of sheets of newspaper on the worktop or table that you will be working on. So, you have all of your supplies, here’s how to go about making your own homemade vaporizer out of a lightbulb.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |